DeAmp Transparent Sound Absorbing Panels offer a solution for effectively managing acoustic challenges arising from spaces dominated by glass or other hard surfaces.
In the context of contemporary interior design trends, which often seek to harmonize "enclosed openness," Deamp's transparent and translucent panels provide a unique tool to address these challenges without compromising the original vision of architects and designers.
By deploying DeAmp panels in hard-surfaced rooms, excessive reverberations are effectively absorbed, mitigating the undesirable reverberation cacophony. The application of DeAmp panels in such highly reverberant environments enhances speech intelligibility while preserving the visually open design concept.
Discreet - Uniquely Transparent - Printed
News Update: Deamp has become certified acoustic panel vendors for Cisco Webex
We are humbled and proud to announce that Deamp panels are recommended in the official acoustic guidelines for video conference rooms.
The 4 minute video above will give you a quick insight into the basics of what makes a video conference room function good in all aspects regarding sound.
A very good demo showcasing the difference in a good and bad sound video conference room starts at around 2:45, and obviously, the second room contains Deamp panels on the modular glass wall.
Over the years Cisco Systems became aware that glass walls in meeting rooms were increasing in use and essentially to be expected. This introduces surfaces that can reduce the speech intelligibility for meeting participants at both sides of a video conference session.
Covering a hard glass wall with transparent Deamp panels will make it into a large sound absorbing surface while still keeping its transparency. In addition we recommend slightly tilting the panels towards the rear of the room so they also break up flutter echoes often created by parallel hard surfaces.
To delve into the full guide you may click the external Cisco Webex link for the: The Room Preparation Guidelines
How to install the panels?
Deamp panels for meeting rooms simply hang by wires or are fixed by stand-offs, or similar, to create a needed airspace of typically about 10cm (4") between the Deamp panel and the hard glass, wall or ceiling behind.
The panels should create a relatively continuous surface to function properly, but edges can be quite open and thus provide virtually no visible change to the openness of your room.
How to get a quote?
A very quick way is to provide us with the size of your room, an approximate area or the size of your glass areas or free areas where Deamp panels can be installed.
Photos, floor plans, wall elevations, sketches are also welcome and we will quickly be able to give you a quote for your needs and based on our room acoustics experience.